icon

FREE SHIPPING ON ORDERS $100+

icon

BUILD YOUR OWN BOX

icon

SUBSCRIBE & SAVE 10%

icon

FREE SHIPPING ON ORDERS $100+

icon

BUILD YOUR OWN BOX

icon

SUBSCRIBE & SAVE 10%

Cart

Your cart is currently empty.

Continue shopping

Bloody Mary Beef Jerky

Oct 19, 2026 BULK JERKY

JERKY RECIPES · FROM THE VIDEO TO YOUR KITCHEN

Bloody Mary Beef Jerky

Six photo steps. A credited source video. A recipe guide to save.

Bloody Mary Beef Jerky served on a wooden board
Serving illustration. Step photographs below are actual frames from EarthDrop Outdoors’s video.

Tomato-rich Bloody Mary mix gives this beef jerky a savory brunch-inspired flavor. Celery salt, horseradish and hot sauce supply the familiar sharpness, while a mixture of pepper and herb seasonings adds depth. EarthDrop Outdoors demonstrates the marinade with eye of round cut into rounds and strips.

Watch the original video

Video by EarthDrop Outdoors · Watch on YouTube

Ingredients

Starting batch: 2 lb raw lean beef; finished yield varies.

  • 2 lb lean beef eye of round, trimmed
  • 1¼ cups nonalcoholic Bloody Mary mix
  • 1 tbsp Worcestershire sauce
  • 1 tbsp hot sauce
  • 1 tsp celery salt
  • 1 tsp ground black pepper
  • 1 tsp salt-free herb seasoning, such as Mrs. Dash Original
  • 1 tsp Montreal steak seasoning
  • 1 tsp crushed red pepper flakes
  • 1 tsp garlic powder
  • 1 tbsp prepared horseradish

Equipment: sharp knife, cutting board, kitchen scale, covered food-safe container, oven, oven-safe racks, thin-tip food thermometer, clean tongs, and an adjustable-temperature dehydrator.

Allergens: Worcestershire sauce may contain fish; Bloody Mary mixes may contain clam juice, soy, wheat or other allergens. Check all mixer, sauce and seasoning labels.

How to make this jerky

Step 1: Trim and firm the beef

Start with cold, lean beef. Trim away exterior fat and silver skin, then briefly firm the roast in the freezer if it is difficult to slice. Keep raw beef refrigerated at 40°F or below while preparing the other ingredients.

A knife trimming the fat cap from eye of round
Video still: EarthDrop Outdoors. Watch at 1:50

Step 2: Cut even strips

Using a clean sharp knife or a slicer according to its instructions, cut across the grain into even strips about 1/8 inch thick. Keep the thickness consistent and return the sliced beef to the refrigerator while mixing the marinade.

Eye of round being cut across the grain into rounds
Video still: EarthDrop Outdoors. Watch at 2:25

Step 3: Make the marinade

Whisk the Bloody Mary mix, Worcestershire sauce, hot sauce, celery salt, black pepper, herb seasoning, Montreal seasoning, red pepper flakes, garlic powder and prepared horseradish. Mix before adding beef so the dry spices and horseradish disperse throughout the tomato base.

Measured Bloody Mary seasonings added to a mixing bowl
Video still: EarthDrop Outdoors. Watch at 1:10

Step 4: Coat and refrigerate

Turn the beef strips through the marinade until both sides of every piece are coated. Cover in a food-safe container and refrigerate overnight at 40°F or below, turning occasionally. Separate any slices stuck together so the coating reaches every surface.

Bloody Mary marinade being turned through beef in a sealed bag
Video still: EarthDrop Outdoors. Watch at 3:31

Step 5: Heat to 160°F, then dry

Before drying, place the strips and marinade in a saucepan, adding enough water to cover. Bring to a boil and check with a thin-tip thermometer that the thickest strips reach 160°F internally. Work in batches if necessary. Drain with clean utensils and discard the used liquid. Arrange heated strips in a single layer on clean dehydrator racks, leaving air spaces between them. Dry at 145–155°F and check periodically. The dryer air temperature does not verify the temperature inside the meat.

Marinated beef pieces spaced on a dehydrator tray
Source video rack-spacing demonstration; BULK’s extra 160°F heating checkpoint is described in the written instructions. Watch at 4:57

Step 6: Check, cool and refrigerate

Cool a test strip before bending it. Look for a dry center and small cracks rather than a soft, wet middle; return moist pieces to the dryer. Cool the entire batch completely on clean racks before packing. Refrigerate finished jerky and freeze extra portions. A texture test does not establish a safe room-temperature shelf life.

Finished Bloody Mary beef jerky from EarthDrop Outdoors
Video still: EarthDrop Outdoors. Watch at 5:35

Why this flavor works

Celery salt and horseradish make the tomato base recognizable as a Bloody Mary flavor even without alcohol. A seasoned mixer and Montreal blend can both be salty; use the stated quantities and compare labels before substituting a stronger blend.

Serving and storage

Serve a small refrigerated portion with a simple lunch or fresh fruit, keeping the remainder chilled.

Keep the finished jerky refrigerated. Pack only fully cooled strips, keep hands and containers clean, and freeze portions you will not eat promptly. Moisture, thickness, and handling affect keeping quality; this home method does not establish commercial shelf stability.

A ready-to-eat option between batches

For a convenient jerky snack when you are not making a batch, explore BULK Texas Style Original Beef Jerky. Its seasoning and production process differ from this homemade adaptation.

Browse every published BULK jerky recipe.

Sources and further reading

Original BULK adaptation after reviewing the source video’s automatic captions and ingredient discussion. Source footage and creator credit belong to EarthDrop Outdoors. Photographs are timestamped source-video stills. Use the full written method for details.

Save the complete recipe guide

Keep the ingredient list and all six steps together. Save the image for your next batch.

Download the recipe infographic
Bloody Mary Beef Jerky infographic with all ingredient amounts, six instructions, 160°F heating before drying, and refrigerated storage
BULK adaptation inspired by EarthDrop Outdoors. Recipe infographic; follow the full instructions above.

Back to the blog title

Post comment

Please note, comments need to be approved before they are published.